Configurable Outputs
The Mini Commander ACC is the only command control receiver that has
configurable voltage and pulse durations for controlling your
accessories. All
selection of the voltage and pulse settings are accomplished from the
CAB-1tm controller during the configuration phase.
Soft Set Technologytm
The
Mini Commander has exclusive “Soft Set Technology”; which allows you
to change the unit ID (1 to 99) and the voltage/pulse settings without
installing a program/run switch!
Multiple Command Set
Responds
to ENG and ACC commands. When ENG is selected, uni-directional
or bi-directional can motors are supported.
Built in Antenna
The
built in antenna will suffice for many applications.
A connector is provided for an extension antenna when the signal
exposure to the built in antenna is not sufficient.
Small
Size
The
footprint is only 1” x 2” in size.
This permits installation into many operating cars.
No more operating tracks needed!
When the Mini Commander is installed in the operating car and
trackside accessory, they become instantly movable to anywhere on your
layout. Simply pick up power from
the constant track power and use the accessory.
Four
Outputs
For
maximum flexibility, 2 high current (2.0A pulsed - 0.8A continuous)
outputs and 2 low current (0.8A pulsed - 0.4A continuous) outputs
are provided.
Multiple Output Functions
The
outputs are capable of pulse, toggle, and strobe functionality.
The high current outputs are the most flexible allowing the
voltage to be set (2-18v), the output mode (pulse or steady), and
while in pulse mode the length of the pulse can be set (0.25 to 2.0
sec). The low current
outputs work as on / off outputs at a constant 9v.
One low current output is capable of strobe functionality.
|